Boot From SPI Flash

Khadas VIM3/VIM3L contains a 16 MB SPI-Flash that’s used as boot storage; so you can boot from it. This guide is about how to boot from the on-board SPI-Flash.

Build U-boot For SPI-Flash

The U-Boot for SPI-Flash is the same as eMMC U-Boot. We recommend using Fenix Script to build U-Boot, as it’s easy this way.

This guide assumes that you have already setup a basic build environment. If not, please refer to Fenix Usage.

  • Setup Environment:
1
2
$ cd fenix
$ source env/setenv.sh

Select VIM3 or VIM3L board(This is according to your board).

  • Build U-boot
1
$ make uboot

If successful, you will get a U-Boot for the SPI-Flash u-boot.bin, in the directory fenix/u-boot/build.

Burn U-boot To SPI Flash

Copy u-boot.bin to an SD-Card or Thumbdrive (U-Disk) and insert it into your board or load it via TFTP.

Setup serial debugging tool and boot to the U-Boot Command Line.

Load U-boot to DDR

  • Load U-Boot from SD-Card:
1
kvim3#load mmc 0 1080000 u-boot.bin
  • Load U-Boot from Thumbdrive (U-Disk):
1
2
kvim3#usb start
kvim3#load usb 0 1080000 u-boot.bin
  • Load U-boot via TFTP

Please refer here about how to setup the TFTP.

1
kvim3#tftp 1080000 u-boot.bin

Burning

1
2
3
kvim3#sf probe
kvim3#sf erase 0 +$filesize
kvim3#sf write 1080000 0 $filesize

Tip: This will take a few seconds, please be patient.

Setup bootmode to SPI

If you want to boot from SPI Flash, you have to setup the bootmode to SPI. The default bootmode is boot from eMMC.

  • Check current bootmode:
1
2
kvim3#kbi bootmode r
bootmode: emmc

Current bootmode is boot from eMMC.

  • Setup bootmode to SPI:
1
kvim3#kbi bootmode w spi

Poweroff the system to make it available:

1
kvim3#kbi poweroff

Press the POWER key to bootup, you will boot from the SPI-Flash.

Erase the SPI Flash to prevent boot from it

1
2
3
kvim3#sf probe
kvim3#sf erase 0 1000
kvim3#reset

Troubleshooting

  1. Bootmode is boot from SPI, but the u-boot in SPI flash is corrupted, can’t enter u-boot command line.

    1. If u-boot in eMMC is correct, you can try TST mode or try SPI MASKROM to boot from eMMC, then enter u-boot command line, erase the SPI flash or burn the new u-boot to SPI flash.

      Note

      Don’t use your PC to supply the power, or you will enter usb burning mode!

    2. U-boot in eMMC is also corrupted, you have to try TST mode to enter usb burning mode, and flash the image to emmc, then follow step 1).

      Note

      You need to connect the board to your host PC!

Next