How To Boot Into Upgrade Mode

There are 4 ways to boot into Upgrade Mode:

1. Keys Mode (Side-Buttons)
2. Serial Mode
3. TST Mode (Recommended)
4. MRegister Mode

• Keys Mode
• Serial Mode
• TST Mode
• MRegister Mode

1. Power on VIM3.
2. Long press the POWER key without releasing it.
3. Short press the ‘Reset’ key and release it.
4. Count for 2 to 3 seconds, then release the POWER key to enter into Upgrade Mode. You will see the sys-led turn ON when you’ve entered Upgrade Mode.

1. Refer this guide to setup your serial tool for VIM3.
2. Once again, make sure you’ve done the correct connections and setup.
3. Hit any keys at the moment of bootup to stop autoboot. This step will let VIM3 boot into U-Boot Mode.
4. Type run update in the terminal of U-Boot as below. You will see the sys-led turn ON when you’ve entered Upgrade Mode.

1. Power-on VIM3.
2. Quickly press the Function key 3 times in 2 seconds, then release the key.
3. You will see the Power-LED (Blue) blink for about 3 seconds. After the Power-LED (Blue) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode).

1. Power on VIM3.
2. Use a tweezer to short-circuit the two pads of the M register, and without releasing…
3. Short press the Reset key and then release it, to boot into upgroup mode